Product Characteristics

• The battery electrolyte contains fumed silica and there is no flow, no leakage or no gradation of sulfric acid . The battery can be put horizontally or vertically. There is no risk of leakage during the utilization and transportation, and it is safe and reliable.
• The gel electrolyte is in dilute sol state when being injected. Excessive electrolyte can fill in all the space inside battery. Under circumstance of high-temperature and overcharge, the battery will not dry out. The gel battery has large heat capacity and good radiation performance. It is not easy to appear thermal runaway. The battery can work under severe environment.
• The positive plate is tubular plate, which can effectively prevent the active materials from falling off. The positive plate skeleton is made of Pb-Ca alloy through die cast, and the thin and compact crystal grains of alloy ensure good performance of corrosion proof. The negative plate is pasted plate, and the grid is in radial structure, which is favorable for improving the utilization rate of active materials and is favorable for discharging at large current. Pb-Ca alloy is adopted and the voltage of hydrogen evolution is high. Unique lead paste formula enables perfect recovery performance of battery recharging after deep discharging. The battery has strong cycle and duration performance, sufficient capacity and long life.
• Adopt PVC-SiO2 separator produced by European AMER-SIL Co., which is with tiny holes and is special for gel battery. The separator has high porosity and low resistance, and the internal resistance of battery is low.
• Adopt imported safety valve. The open and close valve has constant pressure and the reliability is high, which can prevent case swelling, breaking and electrolyte dry out.
• The ABS case and lids of the battery is imported from Italy , which is sealed with resin imported from Germany, so that to ensure no-leakage and to prevent air leakage.
• The terminal is compounding type with inlaid lead copper core. It is processed through die cast and is sealed with imported resin and by imported special equipment. Due to its unique sealed structure of terminal, the seal between case and lid of battery and metal battery terminal is not the direct agglutination between sealant and metal surface, instead, it is the agglutination with the protective sleeve of organic materials and terminal, which makes the seal reliable.
• The closed connection soft thread of terminal post can effectively prevent short circuit due to accidents or avoid risk of suffering from electric shock.

Environment Requirements

• The altitude shall not exceed 4000m(If the utilization altitude exceeds 4000m, it shall be remarked during order.)
• Environmental temperature: -20℃~+50℃(environmental temperature for best utilization +20℃~+30℃)
• Relative humidity≤90%
• The battery shall be far away from fire and organic solvent, and shall be protected from the sunshine. The batteries in the same group shall be utilized at the same environmental temperature.
• Charging voltage: 2.35V/piece of battery(balance charging, 25℃),2.25V/piece of battery(float charging, 25℃)

Main Technical Specifications

• The battery has a long service life, it can operate under float charging for 12~14 years(25℃), and the cycle service life is long.
• The self-discharged electricity of the battery is very low. When the battery is put aside for two years at 20℃, the self-discharged capacity is lower than 40% of the rated capacity.
• The battery has strong ability to recover from deep discharging. Within 12 hours after deep discharging, the battery can be charged to 95% of the rated capacity.
• The gas recombination efficiency exceeds 99%

Main electric performance parameters

1. Discharge current at different discharge rate at terminal volt 1.80v/cell (A)(25℃)

2. Long time discharging capacity (Ah)

Note:the environmental temperature is at 20℃